You can also use a long-handled brush if you don’t want to use your vacuum cleaner. Clean out the exhaust vent by vacuuming it out with your home vacuum cleaner.Disconnect the vent from the dryer duct (it might have a clamp on it that you’ll need to loosen).You will need to pull the dryer out from the wall or its cabinet to be able to access it. You can also keep your thermal fuse from blowing by regularly cleaning out the lint trap/filter. So, if you give the exhaust vent a regular clean, it should stop the thermal fuse from blowing again. This is because when the exhaust vent is blocked hot air cannot properly get distributed out of the dryer and this causes it to overheat. The main reason that a thermal fuse will blow is a blocked exhaust vent. How to Stop the Thermal Fuse from Blowing Again To ensure that the thermal fuse doesn’t blow again, please read our tips below. Hopefully, at this point, the dryer is now working again. Turn your dryer on and test if it now works.Reconnect the dryer back up to the power.Thread the screws back in to ensure it stays in place. Attach the wires into the new thermal fuse, and then attach it in place in the dryer.Once located, remove the thermal fuse by unthreading the mounting screws that hold it in place, and then disconnect the wires that are attached to it.If you haven’t already, you will need to remove the top and/or side panels of the dryer so you can access the thermal fuse.Make sure that the power supply to your dryer is turned off.To replace the thermal fuse, you need to: All of the major dryer manufacturers, such as Maytag, Samsung, Whirlpool, and LG, make and sell replacement thermal fuses and they thankfully don’t cost a lot of money. Once you have confirmed that the thermal fuse has blown, the next thing to do is to purchase the correct replacement part. However, if the test shows no continuity, this will confirm that your thermal fuse is faulty/blown and needs to be replaced (see below). If the test shows that the thermal fuse has continuity, it means it is working correctly, and you can move on to checking the next component.Once the wires are removed, you can use your multimeter to test the thermal fuse for continuity.Once located, disconnect the thermal fuse from the wires that are plugged into it.You will have to remove some of the dryer sides and/or top panels to access it. It is one to two inches long and is located on the exhaust duct (consult your user manual if necessary).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |